Laboratory Mechanical Steam Jet Mill Pulverizer

Everyone knows that choosing a product or service, to learn from all aspects of the milling machine processing, service, quality, etc.

Laboratory Mechanical Steam Jet Mill Pulverizer is a high-speed airflow to form a high-speed airflow using multiple relative-arranged nozzles to achieve ultrafine pulverization. The crushed material enters the grading chamber with the rising airflow. Since the grading rotor is high-speed rotation, the particles are subjected to the centrifugal force generated by the hierarchical rotor, and the center of heart is generated by the viscous effect of the airflow. When the centrifugal force of the particles is greater than the heart force, that is, the fractional particle diameter The coarse particles return to the pulverizing chamber to continue the impact, fine particles flow into the cyclone separator, collectors, and the gas is discharged from the air.

Low temperature without medium smashing, ensuring high purity and physical characteristics of the product. The equipment runs no dust pollution in a negative pressure state. The full use of jet is more than 30% of the conventional gas flow milling machine, and the grading accuracy is higher. The Erbai equipment is small, the structure of the pulverizer can be highly processed so far powder, avoiding the wear of the horizontal grading machine grading part. Under the same material, the service life of the equipment is multiplied by the international similar products. Small granularity is wide, and the product particle size can be arbitrarily adjusted within 1-74um.

Let's take a look at how to extend the use of Laboratory Mechanical Steam Jet Mill Pulverizer:

1, strictly follow the operating procedures;

2, easy to damage parts should pay attention to time check, timely replace.
3, the device body has no rotating components, not affected by the lifetime of the bearing. However, due to the difference in powder hardness, the degree of wear is different, especially the wear of the hierarchy knife tip, our body part uses special material production, the use of the knife tip is at least more than one year, the knife tip is wear more than 1 cm or more It will affect the grading accuracy, in order to avoid affecting product quality, it is recommended to contact us to replace the tool tip;
4. It is recommended to use a long filter device to improve equipment stability, and ensure grading precision.
After long-term use, it is necessary to clean the Laboratory Mechanical Steam Jet Mill Pulverizer. All machines should be disassembled before the airflow pulverizer is cleaned. When cleaning, the power supply can be turned off, and the remaining dust can be removed directly with a brush. We must remember to clean it layer by layer. When unloading, you can remove the four screws on the base and remove the hopper. When sieved, the air pulverizer door can be opened directly, and finally the screen can be disassembled. After removing the mobile gear, release the fastening nut first, then separate the live teeth from the spindle. Then remove the active gear and place it safely. Remove the fixed gear, remove the screw and remove the fixed gear. Be careful when disassembling the air pulverizer and never allows damage to the machine components.

El Pie Composite Powder Laboratory Mechanical Steam Jet Mill Pulverizer Case Sharing: This customer is a renewable resource company, the customer needs to select a different particle size selection of composite powder, and it is necessary to select ultrafine than 30 μm. pink. Investigate a number of domestic grading equipment manufacturers, did not find the right equipment, and finally found the right equipment in our Else, and selected our vertical grading machine equipment. Product particle size: D97 ≤ 30μm hour yield: 80T

Welcome major composite powder manufacturers to visit, incompetent experiments.

Welcome everyone to inquire!