Environmentally friendly Jet Mill Grinder of Ferroalloy has gradually become the market leading to mechanical equipment. At this stage, the modern new mechanical equipment in the machinery processing and manufacturing industry has gradually replaced traditional rough mechanical processing production, so that the production of environmentally friendly machinery It has also become a new dominant leading to the realization of technological innovation and upgrading at this stage.
The distinction between the ultrafine pulverizer and the ordinary pulverizer in the crush:
The ordinary pulverizer can only be smashed into 200 mesh, and 200 mesh is 75 microns. It is the size of the flour, and the ordinary flour is about 80 mesh 160 mes, that is, 90 to 180 microns, this is the thickness of the ordinary pulverizer to print powder.
The ultrafine pulverizer can be super micro-pulverized, can be smashed to 10,000 mesh, 10,000 mesh is 1.3μm, which is equivalent to the particles of the flour, and then pulverized into 70 copies, each size is 10,000 mesh, can It is very thin.
For Jet Mill Grinder Of Ferroalloy, the fault solution is blocked, the small class is to talk about their opinions, I hope to have some reference roles. Crushes blockage is the most common fault of machinery.
It may be one of the most common failures in mechanical design, but because improper operation can cause many faults.
(1) The feeding speed is too fast, the load is increased, causing clogging. During aquaculture, pay attention to the deflection angle of the current table pointer at any time. If the rated current is exceeded, the motor overload and long-term overload will burn the motor. This should be reduced or closed immediately, but it can also be controlled by increasing the feed speed to control the feed speed. Because the speed is fast, the load is large, the load fluctuates great. Therefore, the current of the rolling mill is generally controlled around 85% of the rated current.
(2) The unloading tube is inserted or the interference is too fast, and the universal crusher is blocked, and the delivery device does not match, resulting in weakening or calm of drainage tube. In order to find faults, we must first clarify the export transport equipment, do not change, adjust the amount of feed, and the normal operation of the equipment.
(3) The water content, aging, screening, crushing and sealing material of the hammer hammer are too high, and the general grinding will be blocked. It is necessary to update the work of hammer aging and serious aging.State, and check the screen regularly.Improve the production efficiency of universal grinding machines, improve the reliability of non-blocking and grinding.
Our alpa classifier can meet the slide grading requirements of different yields of different granular sections, if you have a talc grade demand, it is not sure that the grading granularity can not beImplementation, please contact our customer service, we will contact you in the first time and verify that you can achieve your hierarchical needs.
