Many friends who want to produce industrialized must be unfamiliar with Steam Jet Mills of Red Dye. Steam Jet Mills of Red Dye has the characteristics of convenient, fast pulverity, and crushing product quality. It is a very useful. Crush machine.
When the Steam Jet Mills of Red Dye screen material, the screen has good uniformity under the air pressure of the rotating duct. At the same time, under the gravity of the air blower, the screen collects the qualified material, and automatically discharges the material in the front cavity of the valve body by the unloading valve. The raw material powder driven by the compressed air is continuously supplied to the classifier without the need for rotating components. By accurate control of the airflow into three products: F fine powder, m powder and G coarse powder, and collected in subsequent cyclone dust collectors and dust collectors. The material is driven by the blower of the airflow pulverizer. The lower end of the classifier moves upward moves up to the hierarchical area, the strobe, the strongest centrifugal force generated by the high-speed rotation grading turbine. The fine particles that satisfy the particle size requirements are entered into the cyclone separator or dust collector by the gap of the graded wheel blades. After collecting, some of the thick particles of the fine particles disappear and drops along the cylinder wall to two air ports. The crude particles and fine particles are separated by strong purification of the two winds, and the fine particles rises twice as the grade region, and the crude particles fall to the discharge exit.Steam Jet Mills of Red Dye's pulverization chamber is arranged with a specially designed high-pressure intake nozzle, which is purified and dried from the nozzle, forming an ultrasonic gas stream. Materials collide in the center of the high-speed airflow intersection, and it is pulverized in an instant. The pulverized particles rose to the grading chamber, and the qualified particles enter the cyclone separator with the gas, and finally obtain the desired product, the exhaust gas enters the dust collector.
The turbine grading system set in the classification room can obtain a powder of micrometers or even finer. When the pulverized material is pulverized in the pulverized chamber, the same particles at the edge of the turbine will be attached to the two different effort of the centrifuge field (i.e., centrifugal force and airflow resistance generated by turbine). When the particles are large, the centrifugal force is greater than the resistance, and the large particles fly toward the chamber pool wall along the turbine tangential direction, and then returned to the pulverizing chamber to be re-pulverized. When the particles are small, at this time, at this time is less than the resistance, the small particles enter the interior of the turbine with the rising airflow, and collectively collected by the cyclone to qualified products.
STEAM JET MILLS OF Red Dye's daily maintenance
2, when the new machine is running, the transmission belt is easy to elongate, pay attention to adjust the proper tightness of the belt to ensureThe work life of the belt.
3, if the loss case should be checked frequently, replace the quality and production volume in time.
4, the blade, the bushing should often check the wear situation. If the wear is worn, the productivity is lowered, and the particle size is replaced after the particle size is replaced.
5, the host and the graded flow bearing are lipids, and the No. 2 special lipids are used 265-295.
6, the replacement period of the bearing is 2000 hours, and the amount of the grease is filling the amount of the space in the bearing cavity (episode) or 3/4 (lower test) cut, not too much to fill the grease, otherwise The bearing temperature is too high.
7. The spiral feeder has been changed during the change of the lipid of 4,000 hours, and the calcium-based grease is added.
Technical parameters:
Finished particle size: 200 mesh 90% passed
production capacity: 4-5T
